|
Post by revshag on Jun 4, 2012 19:41:45 GMT -5
Hey guys,
I am working with an AMT 84 GMC kit and I am trying to come up with a solution for the body molding found on the 81-87 Chevy/GMC pickups. Scaleproduction had a PE set in their Fall Guy trans kit which is out of production. I thought about using styrene strip but it ends up being too thick. I also thought about using a bed from the AMT 72 Fleetside kit and doing the aluminum foil/epoxy trick that is usually used for badges. The molding should only be about 2mm wide. Any help would be greatly appreciated.
Thanks, Chris
|
|
|
Post by gray07 on Jun 13, 2012 1:40:50 GMT -5
Maybe use the strip, and then sand some off, ive never done this so dont know if it will work, but u could try it on and old model.
|
|