hunter
Junior Member
Posts: 58
|
Post by hunter on Dec 19, 2012 8:48:27 GMT -5
what size braided lines would I use for fuel lines on a pro mod engine. Also, what size fittings would be used with those lines??
|
|
dmk
New Member
Posts: 23
|
Post by dmk on Dec 19, 2012 12:43:26 GMT -5
For a seat of the pants conversion, 1mm equals 1" on 1:1 scale. So for example a 2.5" OD radiator hose on a real car would be about 2.5mm in 1/25 scale.
As far as fuel line, it's often a 5/16 line on a real car (I believe that's ID - Inside Diameter though). So .5mm in scale would be real close.
|
|
|
Post by burwell555 on Dec 19, 2012 12:44:24 GMT -5
What Pro Mod are we talking about? That will help to narrow things down quite a bit.
|
|
hunter
Junior Member
Posts: 58
|
Post by hunter on Dec 19, 2012 12:45:54 GMT -5
How about this one. Attachments:
|
|
|
Post by burwell555 on Dec 19, 2012 12:48:37 GMT -5
The lines comin out of the back of the tank going through the filters into the injector look to be a -10AN size. The fittings are -10AN as well. The line isnt typically measured as a standard size. I will do some looking and see if I can find a conversion chart for ya
|
|
|
Post by burwell555 on Dec 19, 2012 12:56:53 GMT -5
*-AN HOSE SIZING CHART Size Nomical ID -3 3/16"
-4 1/4" -6 3/8" -8 1/2" -10 5/8"
-12 3/4" -16 1" -20 1 1/4" Here you go. Hope this helps!
|
|